Retro Custom offer a wide range of services for your aircooled VW and some of the most common services offered are listed below;

We offer a full drive-in. drive-out lowering service for your VW. From a subtle drop to a full ground scraping slam, we can do it all! If you are unsure how low you want to go, or what you need to buy, drop us an email or give us a call and we will talk  you through your options.

We have extensive experience within the area of narrowed beams. Whether you want a simple 2 inch beam or a 6 inch custom beam, we can build it for you to your requirements. We do not use Urethane in our beams, instead we use original equipment roller bearings and Micarta bushes. We can offer a full drive-in, drive-out narrowing service with all tie rods and torsion leaves narrowed to suit along the tracking set ready for you to drive home.

We can service your car like VW did back in the day! We offer a detailed diagnosis, maintenance and fault repair service. We will present you with a detailed report of your car's health and work done. We offer the following range of service levels;

- Basic Engine Service

- Advanced Engine Service

- Basic Full Service

- Advanced Full Service

Prices for the set services start at £60 + VAT.

However, if you require just a simple oil change or a wheel bearing grease up, we are more than happy to tailor our servicing to your requirements.

We are renowned specialists in aircooled VW electrics and can offer a comprehensive service from a simple fault diagnosis to a complete rewire. We can also design and build a full custom leisure circuit for your bus tailored to your requirements. We are also suppliers of the top quality Optima batteries for the ultimate in auxillary leisure and starting batteries.

We can offer a very comprehensive restoration service ranging from a simple minor rust repair to a full blown nut and bolt concours quality restoration. Our restoration work is carried out to the highest quality as demonstrated on our award winning cars, starting from stripdown. Every nut, bolt and reusable component on your car is catalogued and bagged and returned to the original location on your car after being fully refurbished. All repair work is carried out to the highest standards and returned to original specification where possible. We fabricate by hand many of the repair panels we use to ensure correct fit using the correct gauge steel. Where this is not possible, we prefer to use either original refurbished panels or reproduction panels of the highest quality.

We believe in the old adage 'Do it once and do it right', and this is reflected in the quality of our work.

All restorations undertaken by us are intensively photographed and customers are presented with a CD record containing photos of the restoration from start to finish. Progress photos are also posted on our Blog which is updated daily you can check back and see the progress of your pride and joy.